Filter
Top Products
- 600 -
<1-15> - a value for default-metric.
no - This command is used to reset the default metric of distributed routes to its default value.
Default Setting
Not configured
Command Mode
IPv6 Router RIP Config
10.5.2.6 distance rip
This command sets the route preference value of RIPng in the router. Lower route preference values are
preferred when determining the best route.
Syntax
distance rip <1-255>
no distance rip
<1-255> - the value for distance.
no - This command sets the default route preference value of RIPng in the router.
Default Setting
15
Command Mode
IPv6 Router RIP Config
10.5.2.7 split-horizon
This command sets the RIPngplit horizon mode. None mode will not use RIPngplit horizon mode. Simple
mode will be that a route is not advertised on the interface over which it is learned. Poison mode will be
that routes learned over this interface should be re-advertised on the interface with a metric of infinity (16).
Syntax
split-horizon {none | simple | poison}
no split-horizon
none - This command sets without using RIPngplit horizon mode.
simple - This command sets to use simple split horizon mode.
poison - This command sets to use poison reverse mode.