Filter
Top Products
- 610 -
10.7.2.3 ipv6 pimsm register-threshold
This command configures the Register Threshold rate for the Rendezvous Point router to switch to a
source-specific shortest path. The valid values are from (0 to 2000 kilobits/sec).
Syntax
ipv6 pimsm register-threshold <0-2000>
no ipv6 pimsm register-threshold
no - This command resets the register threshold rate for the Rendezvous Pointer router to the default
value.
Default Setting
0
Command Mode
Global Config
10.7.2.4 ipv6 pimsm rp-address
This command is used to statically configure the RP address for one or more multicast groups. The
parameter <rpaddress> is the IP address of the RP. The parameter <groupaddress> is the group address
supported by the RP. The parameter <groupmask> is the group mask for the group address. The optional
keyword override indicates that if there is a conflict, the RP configured with this command prevails over
the RP learned by BSR.
Syntax
ipv6 pimsm rp-address <rp-address> <group-address> <group-mask> [override]
no ipv6 pimsm rp-address <rp-address> <group-address> <group-mask>
no - This command is used to statically remove the RP address for one or more multicast groups.
Default Setting
0
Command Mode
Global Config