Filter
Top Products
- 794 -
Configurable Data
Router ID - The 32 bit integer in dotted decimal format that uniquely identifies the router within the
autonomous system (AS). If you want to change the Router ID you must first disable OSPF. After you
set the new Router ID, you must re-enable OSPF to have the change take effect. The default value is
0.0.0.0, although this is not a valid Router ID.
OSPF Admin Mode* - Select enable or disable from the pulldown menu. If you select enable OSPF
will be activated for the switch. The default value is disable. You must configure a Router ID before
OSPF can become operational. You do this on the IP Configuration page or by issuing the CLI
command: config router id.