Filter
Top Products
- 867 -
IPv6 Implicit Mode - When ipv6 implicit mode is enabled, interface is capable of ipv6 operation
without a global address. In this case, an eui-64 based link-local address is used. This selector lists
the two options for ipv6 mode: enable and disable. Default value is disable.
IPv6 Routing Operational Mode - Specifies operational state of an interface. Default value is
disable.
Interface Maximum Transmit Unit - Specifies maximum trasmit unit on an interface. It is not valid to
set this value to 0 if routing is enabled. If the value set to 0 that will be changed to default value 1500.
Range of MTU is (1280 to 1500)
Router Duplicate Address Detection Transmits - Specifies number of duplicate address
detections transmits on an interface. DAD transmits values must be in range (0 to 600)
Router Advertisement NS Interval - Specifies retransmission time field of router advertsisement
sent from the interface. A value of 0 means interval is not specified for router. Range of neighbor
solicit interval is (1000 to 4294967295)
Router Lifetime Interval - Specifies router advertisement lifetime field sent from the interface. This
value must be greater than or equal to maximum advertisement interval. 0 means do not use router as
default router. Range of router lifetime is (0 to 9000)
Router Advertisement Reachable Time - Specifies router advertisement time to consider neighbor
reachable after ND confirmation. Range of reachable time is (0 to 3600000)
Router Advertisement Interval - Specifies maximum time allowed between sending router
advertisements from the interface. Default value is 600. Range of maximum advertisement interval is
(4 to 1800)
Router Advertisement Managed Config Flag - Specifies router advertisement managed address
configuration flag. When true, end nodes use DHCPV6. When false end nodes autoconfigure
addresses. Default value of managed flag is disable.
Router Advertisement Other Config Flag - Specifies router advertisement other stateful
configuration flag. Default value of other config flag is disable.
Router Advertisement Suppress Flag - Specifies router advertisement suppression on an
interface. Default value of suppress flag is disable.
Non-Configurable Data
Current State by Prefix - Indicates the state of the IPV6 address. The state is TENT if routing is
disabled or DAD fails . The state is Active if interface is active and DAD is successful.
IPv6 Routing Operational Mode - Specifies operational state of an interface. Default value is
disable.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
Delete - Delete the IPv6 Address configured on an interface.
11.6.3 Viewing IPv6 Interface Summary Page