Filter
Top Products
34 Fortinet Inc.
Rear panel features Getting started
10/100 out of band management module
The 10/100 out of band management module provides dedicated ethernet connection
to manage each FortiBlade-4010 module installed in the FortiGate-4000 chassis. This
out of band connection is not shared by other network connections. The 10/100 out of
band management module contains two 10/100 ethernet interfaces that connect to the
management interface of each FortiBlade-4010 module.
Figure 11: 10/100 out of band management module
Table 6: Management module controls
Button Description
On/Off switch Turns the management module on and off. The management
module must be turned on to establish a serial connection to
the CLI of each FortiBlade-4010 module.
ID dial Set to 0.
Console port Serial connection to the CLI of each FortiBlade-4010 module.
Table 7: KVM switch module LED
LED State Description
ERR Off Normal operation.
Yellow System fault. Contact Fortinet Technical Support.
Note: You can connect to the LAN 1 connector or to the LAN 2 connector but not both.
Table 8: 10/100 out of band management module LEDs
LED State Description
Interface LEDs
Amber The correct cable is in use and the connected equipment has
power.
Flashing
Amber
Network activity at this interface.
Green The interface is connected at 100 Mbps.
LAN 2LAN 1
LAN 1
LAN 2
Mounting Knot Mounting Knot