Filter
Top Products
Getting started Rear panel features
FortiGate-4000 Installation and Configuration Guide 35
Pass-through interface module
Two pass-through interface modules are installed on the FortiGate-4000P. The
internal pass-through interface module connects to each FortiBlade-4010 internal
interface. The external pass-through interface connects to each FortiBlade-4010
external interface. Each pass-through interface module contains ten gigabit copper
1000Base-T ethernet interfaces, one for each FortiBlade-4010 module.
Figure 12 shows the connections between the pass-through interface module ethernet
connectors and the FortiBlade-4010 modules installed in the FortiGate-4000 chassis.
The connections are arranged the same on the internal and external pass-through
interface modules.
Figure 12: Pass-through interface module showing interface correspondence
Switched interface module
Two switched interface modules are installed on the FortiGate-4000S. Each switched
interface module contains two gigabit copper ethernet connectors. You can also
purchase and install optical connectors into the switched interface module small form
factor pluggable (SFP) interfaces. You cannot connect the copper interfaces and the
SPF interfaces at the same time.
Table 9: Pass-through interface module LEDs
LED State Description
Interface LEDs
Amber The correct cable is in use and the connected equipment has
power.
Flashing
Amber
Network activity at this interface.
Green The interface is connected at up to 1000 Mbps.
POWER ON/OFF
LAN 1LAN 2
PWR/KVMSTATUS
KVM/ACCESS
POWER ON/OFF
LAN 1LAN 2
PWR/KVMSTATUS
KVM/ACCESS