Filter
Top Products
FortiGate-4000 Installation and Configuration Guide Version 2.50
FortiGate-4000 Installation and Configuration Guide 61
NAT/Route mode installation
This chapter describes how to install the FortiGate unit in NAT/Route mode. For
information about installing a FortiGate unit in Transparent mode, see “Transparent
mode installation” on page 69. For information about installing two or more FortiGate
units in HA mode, see “High availability” on page 81. For more information about
installing the FortiGate unit in NAT/Route mode, see “Planning the FortiGate
configuration” on page 54.
This chapter describes:
• Preparing to configure NAT/Route mode
• Using the setup wizard
• Using the command line interface
• Completing the configuration
• Connecting the FortiGate unit to your networks
• Configuring your networks
• Completing the configuration
Preparing to configure NAT/Route mode
Use Table 20 to gather the information that you need to customize NAT/Route mode
settings.
Table 20: NAT/Route mode settings
Administrator Password:
Internal interface
IP: _____._____._____._____
Netmask: _____._____._____._____