Filter
Top Products
(1)
(1)
Number in
figure
Description
1Tab
Note -
Confirm that the crossbar cables (optical) are correctly connected and secure.
Note -
After installing the crossbar cables (optical), use the hook-and-loop fastener to bundle
the cables together and secure them to the rear cable support.
Figure 25-7
Crossbar cable (optical) shapes and tabs
Insert the crossbar cable (optical) by holding the connector part of the cable and
inserting it straight into the opening. Do not hold the cable part when inserting the
cable.
25.6 Restoring the System
This section describes the procedure for restoring the system after installing the
crossbar cable (optical). The restoration procedure differs depending on the
maintenance type as follows:
■
Inactive/Cold maintenance
■
System-stopped maintenance
25.6.1 Inactive/Cold maintenance
1.
Connect all pow er cords to the S PA RC M10-4S pow er supply unit requiring
maintenance.
For details, see "6.5.1 Installing the power cord."
Chapter 25 Maintaining the Crossbar Cables (Optical) 397