Filter
Top Products
104 U41243-J-Z156-1-76
Boards in hot-plug PCI slot System expansions
8.5.2 Adding a PCI board
Figure 29: Removing the PCI slot cover
Ê Remove the hot-plug PCI cover (see the section “Removing/mounting the
PCI bus hot-plug cover” on page 87).
Ê Release the PCI locking mechanism for the desired slot and remove the slot
partition.
V CAUTION!
Any unoccupied PCI slots must be equipped with partitions to ensure
that the electromagnetic emission properties of the server are
observed and that the server components are cooled properly.
Ê Start the PCI hot-plug utility from the Control Panel.
Ê If necessary, set jumpers and switches on the new board according to the
instructions supplied by the manufacturer.
Ê Place the new board in the bay and press it carefully into the corresponding
slot.