Filter
Top Products
4-10 SPARC Enterprise T2000 Server Service Manual • April 2007
FIGURE 4-6 Locating the Hard Drive Release Button and Latch
2. Issue the Solaris OS commands required to stop using the hard drive.
Exact commands required depend on the configuration of your hard drives. You
might need to unmount file systems or perform RAID commands.
3. On the drive you plan to remove, push the latch release button (
FIGURE 4-6).
The latch opens.
Caution – The latch is not an ejector. Do not bend it too far to the left. Doing so can
damage the latch.
4. Grasp the latch and pull the drive out of the drive slot.
4.5.2 Replacing a Hard Drive
1. Align the replacement drive to the drive slot.
The hard drive is physically addressed according to the slot in which it is installed.
See
FIGURE 4-6. It is important to install a replacement drive in the same slot from
which the drive was removed.
Latch release
Latch
HDD3
HDD1
HDD2
button
HDD0