Filter
Top Products
42 Fine-tuning the Projector
■ Input Signal
Leave this setting on RGB when a computer is connected to
the
Computer/Component Video port. When a component
video source is connected, choose
YCbCr or YPbPr,
depending on the type of signals produced by your source.
(You can tell which setting is correct by the quality of the
projected image.)
4. When the image is set correctly, press
Esc or Menu. Your settings
are automatically saved.
Adjusting the Sound
You can use the Audio menu to adjust the sound volume or tone.
1. Press the
Menu button. You see the main menu.
2. Use the directional buttons to highlight
Audio. You see the
following:
3. Press
Enter to select the Audio menu.
4. Use the directional buttons to set the following options:
■ Volume
■ Tone (treble/bass balance)
5. When you’re finished adjusting the sound, press
Esc or Menu.
+
-
+
-
Tone
Reset
Volume
Execute
10
Video
Audio
Setting
User's Logo
Advanced
About
Reset All
:
0
:
: Select : Enter
720-730.book Page 42 Thursday, October 30, 2003 11:32 AM