Filter
Top Products
Maintaining and Transporting the Projector 55
5. Use a screwdriver to loosen the two screws holding the lamp in
place. (You can’t remove the screws.)
6. Hold the lamp by the top, as shown, and pull the lamp straight
out.
7. Gently insert the new lamp.
8. Once the lamp is fully inserted, tighten its screws.
9. Replace the lamp cover.
caution
Do not touch the glass
p
ortion of the lamp assembly.
Touching the glass could
result in premature lamp
f
ailure.
warning
This product includes a lamp
component that contains
mercury. Please consult your
state and local regulations
regarding proper disposal and
do not place in a waste
stream.
720-730.book Page 55 Thursday, October 30, 2003 11:32 AM