Filter
Top Products
Basic Configuration
EN/LZT 108 6492 R2 - October 2003
31
(such as a company’s public Web server).
Packets incoming on a DMZ interface – whether
from a LAN or external source – are subject to a
set of protections that is in between public and
private interfaces in terms of restrictiveness.
Lower Interface:
Select an ATM VC interface previously created,
e.g. aal5-0.
EoA interfaces are defined in software, and then
associated with lower-level software and
hardware structures (at the lowest level, they are
associated with a physical port – the WAN port).
This field should reflect an interface name
defined in the next lower level of software over
which the EoA interface will operate.
Conf. IP Address:
Netmask:
0.0.0.0 / 0.0.0.0
To use the HM210dp/di as a bridge, you don’t
need to set the IP address and subnet mask.
Just keep the default.
Use DHCP: Enable / Disable
When Enabled, this setting instructs the device
to accept IP information assigned dynamically by
your ISP’s DHCP server. If the interface will be
used for bridging with your ISP and you will not
be routing data through it, leave this checkbox
unselected.
Default Route: Enable / Disable
Indicates whether the HM210dp/di uses the IP
address assigned to this interface, if any, as its
default route for your LAN. Your system can have
only one default route.
Gateway IP Address:
The external IP address that the HM210dp/di
communicates with via the EoA interface to gain
access to the Internet. This is typically an ISP
server.
4. After entering the fields above, click the Submit button and when
the confirmation page appears, click Close.
5. You will return to the EoA Configuration page and see the newly
added EoA interface: