Filter
Top Products
77
7
RX SETTINGS
Factory settings are in bold. For instructions on how to change a setting, refer to How to change a setting, pp. 73 and 74.
Name Description Settings
ECM RX
FAX/TEL SWITCH
RING START TIME
F/T RING TIME
F/T SW ACTION
INCOMING RING
RING COUNT
MAN/AUTO SWITCH
RING TIME
MEMORY RX
DRPD
NORMAL RING
DOUBLE RING
SHORT-SHORT-LONG
SHORT-LONG-SHORT
OTHER RING TYPE
Enable/disable error correction during reception.
Enable/disable FAX/TEL switchover. When ON, this feature
answers calls, and if no fax tone is detected, the FAXPHONE
rings to alert you of an incoming call.
Set the duration that the FAXPHONE listens for a fax tone
before starting to ring.
Set the length of time the FAXPHONE will ring to alert you of
an incoming call.
Select the action taken after the F/T RING TIME expires.
When the FAXPHONE is set to Fax Only Mode or Fax/Tel
Mode and an extension phone is connected, set the
FAXPHONE to ring when it receives a call.
Set the number of incoming rings before the FAXPHONE
answers.
Determine if the FAXPHONE switches to document receive
mode after the FAXPHONE rings for a specified time when
the FAXPHONE is in the manual receive mode.
Set the amount of time the FAXPHONE will ring before
switching to document receive mode.
Turn on/off memory receiving of a document.
Enable/disable the Distinctive Ring Pattern Detection (DRPD)
feature and assign a setting mode to each ring pattern.
See p. 22.
ON/OFF
8 seconds (0 to 30)
15 seconds (10 to 45)
DISCONNECT/RECEIVE
ON/OFF
2 times (1 to 99)
ON/OFF
10 seconds (1 to 99)
ON/OFF
ON/OFF
TEL-FAX-FAX/TEL SWITCH
TEL-FAX-FAX/TEL SWITCH
TEL-FAX-FAX/TEL SWITCH
TEL-FAX-FAX/TEL SWITCH
TEL-FAX-FAX/TEL SWITCH
Settings