Filter
Top Products
6
6-28 Genius Modular Redundancy Flexible Triple Modular Redundant (TMR) System
User’s Manual – March 1995
GFK-0787B
Configuring a Triplex, Duplex, or Simplex Discrete Input Group
To configure a discrete group, click on that line, or move the cursor there and press the
Return key, or press the highlighted letter key. Then select whether the blocks in the
group are 16-point or 32-point blocks. For example:
A configuration screen like the one shown above right appears. To item on this screen,
use the Tab key or mouse.
Enter a name or a description of up to 12 characters, such as
“in group 3”. This entry is for your information only. It is not used by
the GMR software.
Enter the starting %I Input Table reference for the group. This is the %I
address of the voted input data. The actual %I references used for the
input data from each block are configured using the Logicmaster 90
software. This configuration utility will provide a printout of the addressing
required for Logicmaster 90. The allowable reference ranges are:
0001 to 0112 (788 CPU)
0001 to 2048 (789 CPU)
Duplicate addresses are not allowed within a GBC group. You will not
be permitted to continue until you have entered a unique address.
Enter a serial bus address (also referred to as the “device number”) from
0 to 28. Duplicate bus addresses are also not permitted within a GBC
group. However, each block in the group uses the same serial bus address on its
respective bus.
ID
Start %I
SBA