Filter
Top Products
6
6-34 Genius Modular Redundancy Flexible Triple Modular Redundant (TMR) System
User’s Manual – March 1995
GFK-0787B
Specify how each circuit in a triplex or duplex group should utilize vote
adaptation For a simplex group, this option does not apply.
If a failure (discrepancy fault, or Genius fault) occurs, the GMR software
rejects the faulty data. Depending on the configuration entered here,
input voting may go from three inputs to two inputs to one input, or
from three inputs to two inputs to the configured default value.
For a 4 input/2 output block group, the window shows only four inputs.
Vote Adapt Mode:
For a Triplex group, if voting should go from three inputs to two to one,
select 3–2–1–0. If voting should go from three inputs to two to the
default value, select 3–2–0.
For a duplex group, if voting should go from two inputs to one, select 3– 2– 1– 0.
If voting should go from two inputs to the default value, select 3– 2– 0.
Duplex State:
For a triplex group, the Duplex State determines the vote type when there
are two analog inputs present. It may be configured as the higher actual
input value, the lower value, or an average of the two. For more
information, see page 4-13.
For a duplex group, the voted input data can be:
an average of the two channels that are present.
mid-value selection based upon the two input channels that are present,
with the third (unused) channel assigned to its configured low value.
mid-value selection based upon the two input channels that are present,
with the third channel assigned to its configured high value.
For a simplex group, this information is not used.
Vote
Adaptation