Filter
Top Products
QS–24 UR SWITCH MODULE – QUICKSTART GUIDE
QUICKSTART GUIDE
A valid IP address and subnet mask can now be programmed into the Switch using the IP
config command as follows:
Z Type in “ipconfig ip=“.
Z Enter the IP address (in our example we will use a unique address
between 3.94.247.1 and 3.94.247.254), followed by a space.
Z Type in “mask=“ and enter the mask (in our example system we
would use 255.255.252.0).
Z If a default gateway is also required enter a space and type “dgw=“
Z Enter the IP address of the gateway, then select the enter key.
The switch will then indicate that the parameters have been set.
Z Save the settings using the Save command.