Filter
Top Products
Messages and Signals
119
11. Trouble-
shooting
FAX RX IN MEMORY A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
FUNCTION MODE The FUNCTION key has been pressed.
INTERCOM The INTERCOM key has been pressed to page the
cordless handset, or the cordless handset is paging
the fax machine. Lift the handset to talk. When you
are finished talking, replace the handset.
LCR DOWNLOADING The fax machine has called OpenLCR and is
receiving carrier rate data. This message only
appears if you have registered with OpenLCR.
LINE ERROR Transmission or reception was not successful. Press
the STOP key to clear the message and then try
again. If the error persists, see Line Error on page
112.
LOW BATTERY This will appear if you have pressed the INTERCOM
key to page the cordless handset and the cordless
handset battery is too low for the cordless handset to
respond.
MEMORY IS FULL/
SEE MANUAL
(alternating messages)
The memory is full. You may have too many
messages recorded in the answering system. To
erase messages, see page 47.
This message may also occur during fax reception if
too much data is received before the pages can be
printed out. If faxes have been received to memory
because printing is not possible (an additional
message will indicate the problem), resolve the
problem so that printing can continue (see Substitute
Reception to Memory on page 92).
If you are attempting to transmit from memory, see If
the memory becomes full on page 86.
If you are copying, see If MEMORY IS FULL appears
on page 93.
MEMORY PRINTING The fax is preparing to or printing out a document
from memory.