Filter
Top Products
Grandstream Networks, Inc. HT496 User Manual Page 18 of 29
Firmware 1.0.3.86 Last Updated: 7/2007
TABLE 7: HT496 Basic Configuration Settings Definitions
End User Password
Password to access the Web Configuration Menu. This field is case sensitive with a
maximum length of 25 characters.
Web Port
By default, HTTP uses port 80. This field is for customizable web port.
IP Address
There are two modes to operate the HT496:
DHCP mode: all the field values for the Static IP mode are not used (even though they
are still saved in the Flash memory.) The HT496 acquires its IP address from the first
DHCP server it discovers from the LAN it is connected.
Using the PPPoE feature: set the PPPoE account settings. The HT496 will establish a
PPPoE session if any of the PPPoE fields is set.
Static IP mode: configure the IP address, Subnet Mask, Default Router IP address,
DNS Server 1 (primary), DNS Server 2 (secondary) fields. These fields are set to zero by
default.
DHCP hostname
This option specifies the name of the client. This field is optional but may be required by
some Internet Service Providers. Default is blank.
DHCP domain
This option specifies the domain name that client should use when resolving hostnames
via the Domain Name System. Default is blank.
DHCP vendor class ID
Used by clients and servers to exchange vendor-specific information. Default is blank.
PPPoE account ID
PPPoE username. Necessary if ISP requires you to use a PPPoE (Point to Point
Protocol over Ethernet) connection.
PPPoE password
PPPoE account password.
PPPoE Service Name
This field is optional. If your ISP uses a service name for the PPPoE connection, enter the
service name here. Default is blank.
Time Zone
Controls how the date/time displays according to the specified time zone.