Filter
Top Products
Grandstream Networks, Inc. HT496 User Manual Page 9 of 29
Firmware 1.0.3.86 Last Updated: 7/2007
BASIC OPERATIONS
GET FAMILIAR WITH VOICE PROMPT
HT496 stores a voice prompt menu (Interactive Voice Response or IVR) for quick browsing and simple
configuration. The IVR menu and the LED button work with the FXS port 1 only
. Pick-up the handset
and press the button on the HT496 or
dial “***” to use the IVR menu,
T
ABLE 4: HT496 IVR Menu Definitions
Menu Voice Prompt Options
Main Menu
“Enter a Menu Option”
Press “*” for the next menu option
Press “#” to return to the main menu
Enter 01-05, 07,12-17,47 or 99 menu options
01
“DHCP Mode”,
“Static IP Mode”
Press “9” to toggle the selection
If using “Static IP Mode”, configure the IP address information using
menus 02 to 05.
If using “Dynamic IP Mode”, all IP address information comes from
the DHCP server automatically after reboot.
02
“IP Address “ + IP address The current WAN IP address is announced
If using “Static IP Mode”, enter 12 digit new IP address.
03
“Subnet “ + IP address Same as menu 02
04
“Gateway “ + IP address Same as menu 02
05
“DNS Server “ + IP address Same as menu 02
07
Preferred Vocoder
Press “9” to move to the next selection in the list:
• PCM U/A
• G.723
• iLBC
• G.729
• G.726
12
WAN Port Web Access
Press “9” to toggle between enable / disable
13
Firmware Server IP
Address
Announces current Firmware Server IP address. Enter 12 digit new
IP address.
14
Configuration Server IP
Address
Announces current Config Server Path IP address. Enter 12 digit
new IP address.
15
Upgrade Protocol Upgrade protocol for firmware and configuration update. Press “9” to
toggle between TFTP / HTTP
16
Firmware Version Firmware version information.
17
Firmware Upgrade Firmware upgrade mode. Press “9” to toggle among the following
three options:
- always check
- check when pre/suffix changes
- never upgrade
47
“Direct IP Calling”
Enter a 12 digit IP address to make a direct IP call, after dial tone.
(See “Make a Direct IP Call”.)
99
“RESET”
Press “9” to reboot the device; or
Enter encoded MAC address to restore factory default setting (See
“Restoring Factory Settings”)
“Invalid Entry” Automatically returns to main menu