Grizzly H8246 Switch User Manual


  Open as PDF
of 2
 

WARNING: NO PORTION OF THIS INSTRUCTION SHEET MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

Figure 1.
For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
MODEL H8246
WIDE SINGLE MINI
ON/OFF SWITCH
INSTRUCTIONS
Introduction





Specifications


To reduce risk of serious burns, electrocu-
tion or death when installing this switch:
• Only use this switch to replace an exist-
ing component switch that has the same
physical configuration and equivalent
electrical specifications/ratings.
• Installationmustonlybeperformedbyan
electrician or qualified service personnel,
and all applicable electrical codes must
be adhered to.
• Turn off and completely disconnect all
power sources to the component before
installing the switch.
• Onlyinstallthisswitchonthe"hot"wires.
Do not install it on the neutral or ground
wires. Otherwise, the component could
still be receiving live current even when
the switch is turned OFF.
• Do not use this switch in wet or damp
locations, or near explosive fumes or
flammable liquids. It is not sealed or rated
for these environments.
• Make sure there is a verified compo-
nent ground on the circuit this switch is
installed.