Home Automation 38A00-3 Switch User Manual


 
HAI UPB™ Lumina Mode Controller
Installation and Operating Instructions
For the following Model:
38A00-3 HAI UPB™ Lumina Mode Controller
READ THESE INSTRUCTIONS BEFORE INSTALLING DEVICE
This HAI UPB™ Lumina Mode Controller is intended for installation in accordance with the National Electrical Code and local
regulations. It is recommended that a qualified electrician perform this installation. Retain these instructions for reference.
This product is for indoor use only. Connect only copper or copper clad wire to this device.
Important Notes Prior To Installation
Be sure that all power to the load has been disconnected by turning off the circuit breaker. Installing an HAI UPB™ Lumina Mode
Controller with power on may expose you to dangerous voltage and may damage the device.
HAI UPB™ Lumina Mode Controller Overview
The HAI UPB™ Lumina Mode Controller (Figure 1) is used to easily change the mode before leaving your house, going to bed,
arriving home, going on vacation, entertaining for the evening, or any other special event. It uses the UPB™ two-way powerline
communication technology to communicate with a Lumina controller to initiate programs for preset lights and temperatures.
The HAI UPB™ Lumina Mode Controller has six pushbuttons labeled AWAY, HOME, SLEEP, VAC (Vacation), SPCL (Special),
and PARTY. Each pushbutton is slightly backlit so that the buttons can be seen in a dark room. The pushbuttons of the current
Lumina Mode will be distinctly illuminated, so that you can always tell which mode you are currently in just by glancing at the
Lumina Mode Controller.
To change the current mode from a Lumina Mode Controller, simply press the desired mode button. The new mode button will
illuminate and the lighting and temperatures in your home will be changed accordingly.
AWAY
SLEEP
SPCL
HOME
PARTY
VAC
Figure 1 - HAI UPB™ Lumina Mode Controller
38I00-3, Rev B