Filter
Top Products
IMAGETEAM™ 2020/5620 System Manual 2 - 15
Wand Emulation Idle
The idle describes the state of the scanner when no data is being transmitted.
When in Wand Emulation mode, you must set the scanner’s idle state to match
the idle state for the device to which the scanner is connected.
Default = Idle
High
.
Wand Emulation Data Block Size
This transmits the data in smaller blocks to prevent buffer overflow.
Default = 40.
Wand Emulation Delay Between Blocks
This sets the delay time between data blocks.
Default = 50ms.
* Idle High
Idle Low
20
80
* 40
60
5ms
500ms
* 50ms
150ms