Havis-Shields C-TCB-MAK Network Card User Manual


  Open as PDF
of 2
 
INSTALL INSTRUCTIONS C-TCB-MAK
MONITOR ADAPTER KIT
FOR USE ON ALL STRAIGHT POLED C-TCB’S
TOOLS REQUIRED:
Ratcheting wrench
Sockets - 7/16”, ½”
Combination wrenches - 7/16”, ½”
T-20 torx bit
3/16” Allen key
HARDWARE:
ITEM # QTY DESCRIPTION PART #
1 1 Rotating TCB plate CM93073-2
2 1 Bolt/nut weldment CM001491
3 1 5/16-24 Flex nut CM86209
4 1 5/16-24 x 1” Socket head cap screw CM86502
5 2 5/16” Belleville stainless washer GSM31092
6 2 5/16” x 2” Fender washer GSM31020
7 1 5/16-24 Hex jam nut GSM30070
8 1 5/16-18 nylock nut GSM30017
Always
!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
#2
#3, 4, 5, 6, 7
#1
Straight inner
pole assembly
#5, 8