Hearth and Home Technologies WSK100 Switch User Manual


  Open as PDF
of 4
 
1
Printed in U.S.A. Copyright 2007
Hearth & Home Technologies Inc.
20802 Kensington Boulevard, Lakeville, MN 55044
2050-910G 7/07
WSK100, WSK200 and WSK210 Wall Switches
- Installation and Operating Instructions -
Figure 1. Items included in the WSK100 Wall Switch Kit
INTRODUCTION
The WSK100 and WSK200 wall switches are designed to
switch the fi replace on or off, and the pilot function activates
the pilot fl ame as well. These wall switches interface with
Intellifi re
™
systems only.
INSTALLATION PRECAUTIONS
This wall switch is tested and safe when installed in
accordance with this installation manual. Do not install
any components that may be damaged. Do not modify,
disassemble, or substitute any of the components included
with this kit. Installation of this unit must be done by a
qualifi ed service technician.
Placement of this wall switch may affect performance. An
assessment of the space should be done prior to installation
for optimum performance. See Section 1.1 for location
recommendations.
NOTE: The electrical junction box provided with the fi replace
must be wired with 110 VAC before installing this kit. See
owner’s manual for details.
WARNING
Shock Risk
WARNING
Inspect components for damage. Damaged
parts may impair safe operation.
• Do NOT install damaged components.
• Do NOT install incomplete components.
• Do NOT install substitute components.
Report damaged parts to dealer.
DO NOT DISCARD THIS MANUAL
CAUTION
• Important installation and operation instruc-
tions included.
• Read, understand and follow these
instructions for safe installation and
operation.
• Leave this manual with party responsible
for use and operation.
Do NOT provide any power to this unit
until all wiring is complete.
•
May destroy parts of this device and
render it unusable.
May lead to possible electrical shock.
•
NOTE: All wiring should be done by a qualifi ed electrician and
shall be in compliance with local codes and with the National
Electric Code ANSI/NFGA No. 70 - current (in the United
States), or with the current CSA C22.1 CANADIAN ELECTRIC
CODE (in Canada).
Figure 2. Items included in the WSK200 and WSK210 Wall Switch
Kit. (Delay circuit not shown).
Wall Switch Control Box Wiring Harness
Wall Switch Control Box Wiring Harness
next