Filter
Top Products
Remove the optical drive connector cable:
1. Release the optical drive cable from the clips (1) built into the base enclosure.
2. Remove the two Phillips PM2.0×5.0 screws (2) that secure the optical drive connector to the
base enclosure.
3. Remove the optical drive connector (3) from the base enclosure.
Reverse this procedure to install the optical drive connector cable.
Display assembly
Description Spare part number
15.6-in, HD, LED, BrightView display assembly (includes microphone and wireless antenna transceivers and cables)
Equipped with webcam, in black finish 664237-001
Equipped with webcam, in charcoal gray finish 645093-001
Not equipped with webcam, in charcoal gray finish 645092-001
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
62 Chapter 4 Removal and replacement procedures