HP (Hewlett-Packard) J4500 Printer User Manual


 
Fax over the Internet
You may subscribe to a low cost phone service that allows you to send and receive
faxes with your device by using the Internet. This method is called Fax over Internet
Protocol (FoIP). You probably use a FoIP service (provided by your telephone
company) if you:
Dial a special access code along with the fax number, or
Have an IP converter box that connects to the Internet and provides analog phone
ports for the fax connection.
NOTE: You can only send and receive faxes by connecting a phone cord to the
port labeled "1-LINE" on the device. This means that your connection to the
Internet must be done either through a converter box (which supplies regular
analog phone jacks for fax connections) or your telephone company.
Some Internet faxing services do not work properly when the device is sending and
receiving faxes at high speed (33600bps). If you experience problems sending and
receiving faxes while using an Internet fax service, use a slower fax speed. You can
do this by changing the Fax Speed setting from High (the default) to Medium. For
information on changing this setting, see
Set the fax speed.
If you have questions about internet faxing, contact your internet faxing services
support department.
Test fax setup
You can test your fax setup to check the status of the device and to make sure it is set
up properly for faxing. Perform this test after you have completed setting up the device
for faxing. The test does the following:
Tests the fax hardware
Verifies the correct type of phone cord is connected to the device
Checks that the phone cord is plugged into the correct port
Checks for a dial tone
Checks for an active phone line
Tests the status of your phone line connection
The device prints a report with the results of the test. If the test fails, review the report
for information on how to fix the problem and rerun the test.
To test fax setup
1. Set up the device for faxing according to your particular home or office setup
instructions.
2. Make sure the ink cartridges are installed, and that full-size paper is loaded in the
main tray before starting the test.
3. From the device control panel, press Setup.
4. Press right arrow
to select Tools, and then press OK.
Test fax setup
59