Filter
Top Products
To set the fax error-correction mode
1. Press Setup.
2. Press the right arrow
to select Fax Settings, and then press OK.
3. Press the right arrow
to select Error Correction, and then press OK.
4. Press the right arrow
to select On or Off, and then press OK.
Set the dial type
Use this procedure to set tone-dialing or pulse-dialing mode. The factory-set default is
Tone. Do not change the setting unless you know that your phone line cannot use
tone dialing.
NOTE: The pulse-dialing option is not available in all countries/regions.
To set the dial type
1. Press Setup.
2. Press the right arrow
to select Basic Settings, and then press OK.
3. Press the right arrow
to select Tone or Pulse, and then press OK.
4. Press the right arrow
to select the appropriate option, and then press OK.
Set the redial options
If the device was unable to send a fax because the receiving fax machine did not
answer or was busy, the device attempts to redial based on the settings for the busy-
redial and no-answer-redial options. Use the following procedure to turn the options on
or off.
• Busy redial: If this option is turned on, the device redials automatically if it
receives a busy signal. The factory-set default for this option is ON.
• No answer redial: If this option is turned on, the device redials automatically if the
receiving fax machine does not answer. The factory-set default for this option is OFF.
To set the redial options
1. Press Setup.
2. Press the right arrow
to select Fax Settings, and then press OK.
3. Press the right arrow
to select Redial Options, and then press OK.
4. Press the right arrow
to select the appropriate Busy Redial or No Answer
Redial options, and then press OK.
Set the fax speed
You can set the fax speed used to communicate between your device and other fax
machines when sending and receiving faxes. The default fax speed is Fast.
If you use one of the following, setting the fax speed to a slower speed might be
required:
• An Internet phone service
• A PBX system
Chapter 6
58
Fax