Filter
Top Products
ASSEMBLY INSTRUCTIONS
Adapter — KIT NO. 873440
For Hobart PRIME™ Mixer-Grinders with 15° incline cylinder and Hollymatic model 120 Bulker.
PART NO. NAME OF PART AMT.
873440 Adapter Kit (complete) .......................................................... 1
873430 Adapter, Bulker ........................................................................ 1
873437 Long Support Rod.................................................................... 1
F-34483 Assembly Instructions ............................................................. 1
ASSEMBLY
WARNING: DISCONNECT ELECTRICAL POWER.
1. Remove the paper roll from the
Hollymatic Model 120. Pull the pin
out of the bracket underneath the
bulker. Remove the Bulker from its
pedestal by lifting straight up.
Carefully set the Hollymatic Model
120 Bulker on its side (Fig. 1).
2. Unscrew the height adjustment
screw and remove the support rod
from the pedestal. The long rod
from the kit must be used with the
Hobart PRIME™ Mixer-Grinder.
3. Assemble the Long Support Rod
from the kit into the pedestal
base making sure the grooved
part of the Support Rod is up.
Re-tighten the height adjustment
screw so the support rod is
stable, Fig. 2.
PL-41437-1
HOLLY BULKER
BRACKET
PAPER ROLL
PIN
Fig. 1
PL-41438-1
LONG SUPPORT ROD
PEDESTAL
HEIGHT ADJUSTMENT SCREW
BASE
Fig. 2
701 S. RIDGE AVENUE
TROY, OHIO 45374-0001
937 332-3000
www.hobartcorp.com
FORM 34483 (May 2000)