Honeywell 1250gAP All in One Printer User Manual


 
3 - 15
Character Deactivation Mode
If you have sent a character from the host to trigger the scanner to begin scan-
ning, you can also send a deactivation character to stop scanning. Scan the On
bar code below to use character deactivation, then use Deactivation Character
(following) to select the character you will send from the host to terminate scan-
ning. Default = Off.
Deactivation Character
This sets the character used to terminate scanning when using Character
Deactivation Mode. On the ASCII Conversion Chart (Code Page 1252) on
page A-3, find the hex value that represents the character you want to use
to terminate scanning. Scan the bar code below, then use the
Programming Chart to read the alphanumeric combination that represents
that ASCII character. Scan Save to finish.
* Off
On
Deactivation Character