Honeywell 2700 Scanner User Manual


 
2 - 14
The images from the video camera are shown in the upper left corner of the scanner’s vertical tower.
Connecting EAS
Checkpoint®
When connecting to a Checkpoint EAS system, connect the Checkpoint EAS interlock cable (if required) to the EAS inter-
lock port on the left side of the 2700 (see Device Ports on page 2-8). Connect the Checkpoint antenna cable to the antenna
port on the underside of the 2700, shown above. Refer to EAS Settings beginning on page 10-1 for configuration codes
and further EAS programming information.
Sensormatic®
When connecting to a Sensormatic EAS system, connect the Sensormatic RS232 control line to the EAS interlock port on
the left side of the 2700 (see Device Ports on page 2-8). Connect the Sensormatic antenna cables to the to the multi-col-
ored antenna connectors on the underside of the 2700, shown above. Contact Tyco for further information about Sensor-
matic installation and configuration. Refer to EAS Settings beginning on page 10-1 for Stratos bioptic configuration codes
and further EAS programming information.
Connecting to the POS System
Step 1. Turn off the host system.
Step 2. If using a single cable, plug one end of the interface cable into the port labeled for your interface on the right side
of the Stratos bioptic:
USB: Scanner USB to Host
RS232: Scanner RS232 to Host
RS485: Scanner RS232 to Host
When using a dual cable, plug an RS232 cable into the Scale to Host port on the right side of the Stratos bioptic.
(Internal)
Scale Display In
(Internal)
Scale Com In
Aux RS232 In
EAS Interlock
AUX USB In
Camera
Video In
Camera
+12V Out
Checkpoint EAS Antenna Port
Sensormatic
Antenna
Connectors