Filter
Top Products
3 - 2
Resetting the Custom Defaults
If you want the custom default settings restored to your scanner, scan the Activate Custom Defaults bar code below. This is
the recommended default bar code for most users. It resets the scanner to the custom default settings. If there are no custom
defaults, it will reset the scanner to the factory default settings. Any settings that have not been specified through the custom
defaults will be defaulted to the factory default settings.
Programming the Scanner Interface - Plug and Play
Plug and Play bar codes provide instant scanner set up for commonly used interfaces. They are also used to program the scan-
ner portion when using a dual cable interface.
Note: After you scan one of the codes, power cycle the scanner to have the interface in effect.
For scale and scanner/scale interfaces, refer to Programming the Scale Interface on page 6-1. For EAS Interfaces, refer to
Programming the EAS Interface on page 10-3.
RS232 Serial Port Interface
The RS232 Interface bar code is used when connecting to the serial port of a PC or terminal. The following RS232 Interface
bar code programs a carriage return (CR) and a line feed (LF) suffix, baud rate, and data format as indicated below.
RS232 OPOS Scanner Only - Dual Cable
Scan the following bar codes to configure the Stratos bioptic as a scanner only, using the OPOS drivers in dual cable mode.
In a dual cable environment, the scanner and scale work independently. In this mode, the host must have a dedicated
RS232 port to receive the scale data and the bar code data is sent via its own cable to a separate communication port. The
bar codes below program the following baud rates and data formats:
Option Setting
Baud Rate 9,600 bps
Data Format 8 data bits, no parity bit, 1 stop bit
Programming
Code
Data Format
9600 Baud 8 data bits, no parity bit, 1 stop bit
38,400 Baud 8 data bits, no parity bit, 1 stop bit, Flow
Control, No Timeout
Activate Custom Defaults
RS232 Interface