Filter
Top Products
3 - 7
**Suffixes programmed for Code 128 with IBM 4683 Port 9 HHBCR-2 Interface
IBM 46XX - Scanner Only
The following bar code sets the scanner for IBM 46XX RS485 emulation, scanner-only protocol defaults.
IBM Port 17 Interface - Scanner Only
The following bar code forces the Stratos bioptic to operate as an IBM tabletop scanner when connected via a single
RS485 cable at address 4A.
RS485 Packet Mode
The following selection allows you to break up large bar code data into smaller packets on an IBM POS terminal. To break
up large bar codes into small packets, scan the Packet Mode On bar code, below. Scan the Packet Mode Off bar code if
you want large bar code data to be sent to the host in a single chunk. Default = Packet Mode Off.
RS485 Packet Length
If you are using Packet mode, you can specify the size of the data “packet” that is sent to the host. Scan the Packet
Length bar code, then the packet size (from 20 - 255) from the Programming Chart inside the back cover of this man-
ual, then Save. Default = 40.
IBM 46XX - Scanner Only
IBM Port 17 Interface - Scanner Only
* Packet Mode Off
Packet Mode On
Packet Length