Honeywell 2700 Scanner User Manual


 
3 - 32
RS232 Defaults
If you want the custom RS232 default settings restored to your scanner, scan the RS232 Defaults bar code below. This
resets the scanner to the custom default settings (see Setting Custom Defaults on page 3-1). If there are no custom
defaults, it will reset the scanner to the factory default settings. Any settings that have not been specified through the cus-
tom defaults will be restored to the factory default settings.
NCR Modifiers
NCR ACK/NAK
This is an NCR communication protocol for ACK/NAK processing. Default = NCR ACK/NAK Off.
NCR Modes
Scan one of the following bar codes to set the message mode for an attached NCR device.
NCR Scanner Only Mode
Scan the NCR Scanner Only Mode On bar code to select the NCR scanner-only message format. (For more informa-
tion, refer to the NCR Scanner/Scale Programmer’s Guide.) Default = NCR Scanner Only Mode Off.
RS232 Defaults
* NCR ACK/NAK Off
NCR ACK/NAK On
* NCR Scanner Only Mode Off
NCR Scanner Only Mode On