Honeywell 4820 Scanner User Manual


 
3 - 8
To rename image scanners with sequential, numeric names, scan the barcodes
below.
Scan the Reset code after each name change and wait for the scanner
to re-link to the base before scanning another barcode to rename the next
image scanner.
Alternatively, you may change the name with a barcode command if you cannot
send serial commands to the base. One way to do this is to scan the barcode
below and scan a number for the image scanner name. For example, if you had
7 image scanners to one base, scan the barcode below with the first image
scanner, scan the 1 barcode on the Programming Chart inside the back cover
of this manual and scan Save. Then scan the Reset barcode and wait for the
scanner to re-link to the base before scanning the next barcode. Repeat that
process for image scanner number 2, 3, 4 etc.
If you want to assign an alphabetic name to the image scanner, create a Code
128 barcode containing “~BT_NAM
name
.” followed by a FNC3 character (hexi-
decimal 83), where
name
is the new image scanner name. Scan the Reset
0001
0002
0003
0005
0007
0004
0006
Reset
Image Scanner Name