Filter
Top Products
2 - 2
Initial Setup
Following are the steps you might take when setting up a new Ring Scanner. More instruction for each step is listed later in this
guide. Contact Customer Support (page 7-1) if you need additional help.
Accessory installation or removal should be performed on a clean, well-lit surface. When necessary, protect the work surface,
the Ring Scanner, and components from electrostatic discharge.
Hardware Setup
1. Determine which hand will contain the assembly. See Determine Left or Right Orientation (page 2-3).
2. Connect the ring cable connector to the body worn computer. See Connect to Terminal (page 2-4).
Components
Ring Imager / Ring Scanner
The ring imager can scan and decode 1D and 2D bar codes. The imager has three small illumination LEDs at the top of the
scan window or aperture.
The ring scanner can scan and decode 1D bar codes. The scanner does not have illumination LEDs.
The ring sends the collected bar code data to the mobile computer for processing.
Do not touch, push against or brace your finger on the scan aperture at any time.
When new, there is a clear, tabbed protective film covering the ring decoder scan window. Remove and discard the clear,
tabbed protective film before scanning a bar code.
Ring Imager / Ring Scanner for Dolphin 70e Black in Wearable Sled.
Ring Imager / Ring Scanner for HX2 and HX3.
Ring Imager Ring Scanner Cable Connector
Ring Imager Ring Scanner Cable Connector