Honeywell 8600 All in One Printer User Manual


 
3 - 20
Next, scan two numeric bar codes that correspond to the desired value using the Keypad Number Symbols at the end
of this chapter. Time durations of less than 1.0 second require a leading zero. For example, a value of 4.5 seconds is
selected by scanning the “4” and the “5” numeric bar codes. A value of 0.3 seconds is selected by scanning the “0”
and the “3” bar codes.
If you wish to change your selection, scan Cancel on the Keypad Number Symbols page.
The SSI Options bar codes are directed toward the host programmer when writing host/scanner interface programs for
different hosts. Contact Customer Support (page 7-1) for technical help.
Intercharacter Delay
Intercharacter Delay Default: 0 msec
Select the intercharacter delay option matching host requirements. The intercharacter delay gives the host system
time to service its receiver and perform other tasks between characters.
The delay period can range from no delay to 99 msec in 1 msec increments. After scanning the bar code below, scan
two numerical bar codes to set the delay.
To begin setting the delay value, scan this bar code:
Next, scan two numeric bar codes that correspond to the desired value using the Keypad Number Symbols (page 3-
72) at the end of this chapter. Time durations of less than 1 msec require a leading zero. For example, a value of 25
msec is selected by scanning the “2” and the “5” numeric bar codes. A value of 6 msec is selected by scanning the “0”
and the “6” bar codes.
If you wish to change your selection, scan Cancel on Keypad Number Symbols (page 3-72).
The SSI Options bar codes are directed toward the host programmer when writing host/scanner interface programs for
different hosts.
Parity
A parity check bit is the most significant bit of each ASCII coded character. Select the parity type according to host
device requirements.
Set this parameter by scanning one of the following bar codes.
Odd Parity
The Odd parity bit has a value 0 or 1, based on data, to
ensure that an odd number of 1 bits is contained in the
coded character.
Even Parity
The Even parity bit has a value 0 or 1, based on data, to
ensure that an even number of 1 bits is contained in the
coded character.