IBM 07N4108 Computer Drive User Manual


 
OPTIONS
by IBM
IBM 15/20.4/30 GB Ultra ATA/100 (EIDE) Hard Disk Drives User’s Guide Supplement
The IBM
15 GB, 20.4 GB, and 30 GB Ultra ATA/100 (EIDE) Hard Disk Drives offer a choice of jumper configurations so that the
drive will function properly on the widest range of computers. In some older computers, the BIOS (basic input/output system) will not
recognize a large capacity hard disk drive, such as 2.1 GB, 4.2 GB, 7.9 GB, or 8.4 GB. The following instructions will help you
determine if your computer has one of these BIOS limitations, and what configuration settings your computer requires so that the drive
will be recognized.
Match your drive part number (on the drive label) with one of the diagrams. If the drive part number is 07N4108, 07N4109, or
07N4110, configure your drive using the jumper setting from Set A in Figure 1. If the drive part number is 19K1618, 19K1619, or
19K1620, configure your drive using the jumper setting from Set A in Figure 2.
Return to the User’s Guide and follow instructions beginning with “Determining Where to Begin” in the Installation Guide (Part 1).
19K4540
Printed in the U.S.A.
Copyright International Business Machines Corporation 2000. All rights reserved
Note to U.S. Government Users – Documentation related to restricted rights – Use, duplication or disclosure is subject to restrictions
set forth in GSA ADP Schedule Contract with IBM Corp.
HelpCenter, IBM, and OS/2 are trademarks of the IBM Corporation in the United States, other countries, or both.
Microsoft, Windows, and Windows NT are trademarks of Microsoft Corporation in the United States or other countries or both.
*P19K4540*
If you are using Microsoft
Windows
3.1, Windows 95, or Windows 98:Disregard this section on setting jumpers; instead, read the “Installing
DiskGo!” section in the User’s Guide.
If you are using Microsoft Windows 2000 Professional, Microsoft Windows NT
Workstation or IBM
OS/2
: Read this entire section on
setting jumpers; this information supplements the information in your User’s Guide.
Figure 1
Jumper settings for drives with the following Part
Numbers ONLY: 07N4108, 07N4109, or 07N4110
Set A
Set B for overcoming
BIOS limitations
(2 GB clip setting)
1Master/single
2Slave
3Cable select
4Slave present
Figure 2
Jumper settings for drives with the following Part
Numbers ONLY: 19K1618, 19K1619, or 19K1620
Set A
Set B for overcoming
BIOS limitations
(7.9 GB clip setting)
1Master/single
2Slave
3Cable select
1