Filter
Top Products
Appendix C. General Attributes Required When Using a TTY
Terminal
The following general attributes are the default settings for the diagnostic programs. Be
sure your terminal is set to these attributes.
Note: Set these attributes before the diagnostic programs are loaded.
General Setup
Attributes
3151
/11/31/41
Settings
3151
/51/61
Settings
3161 /3164
Settings
Description
Machine mode 3151 3151 PC 3161 or
3164
The diagnostic programs are set
to emulate use of the 3161 ASCII
Display Terminal. If your terminal
can emulate a 5085, 3161 or
3164 terminal, use these attribute
settings. Otherwise, refer to your
operator’s manual, compare the
attribute descriptions with those
of your terminal, and set your
attributes accordingly.
Generated Code Set ASCII
Screen Normal Normal Uses the EIA-232 interface
protocol.
Row and Column 24 x 80 24 x 80 Uses the EIA-232 interface
protocol.
Scroll Jump Jump Jump When the last character on the
bottom line is entered, the screen
moves down one line.
Auto LF Off Off Off For the ″On″ setting, pressing the
Return key moves the cursor to
the first character position of the
next line. For the ″Off″ setting,
pressing the Return key moves
the cursor to the first character
position of the current line. The
CR and LF characters are
generated by the New line
setting.
CRT saver Off Off 10 The ″10″ setting causes the
display screen to go blank if there
is no activity for 10 minutes.
When the system unit sends data
or a key is pressed, the screen
contents display again.
173