Filter
Top Products
Resetting the LEDs
After the repair action is completed, do the following:
1. Log in as root user.
2. At the command line, type diag.
3. Select Task Selection.
4. Select Log Repair Action.
5. Select the device that was repaired.
6. Press F10 to exit diagnostics.
If the Attention LED remains on after you have completed the repair action and reset
the LEDs, call for service support.
Reporting the Problem
After you have determined which component is failing, report the problem.
1. Record the following information before calling for service:
v Machine type and model number
v Server serial number
v Any error codes that appear in the operator panel display or console
v The adapter or device containing the lit amber-colored LED
2. Call for service. You will be given the choice to replace the failing component
yourself or have a service representative replace it for you. If you decide to replace
the failing component, go to “Repair Action” for instructions.
Repair Action
After you have determined which component is failing, a repair action is necessary.
1. Run the system verification procedure. Refer to Installing Options in the
pSeries 630
Model 6C4 and Model 6E4 Installation Guide
for instructions on component
installation, removal and replacement.
2. Record the following information before calling for service:
v Machine type and model
v Server serial number
v Any error codes that appear in the operator panel display or on the console
v Any LEDs that are lit on the indicator panel
3. Call for service.
4. After the repair action is completed, go to “Resetting the LEDs”, and reset the
LEDs.
Chapter 2. Using the System 15