Filter
Top Products
58 Hardware Maintenance Manual: xSeries 330
Note: It is very important to replace the clear shield.
5. To remove microprocessor #1:
a. Remove the adapter board retainer latch:
1) Lift up on the release latch.
2) Remove the screws and put them in a safe place.
3) Lift the retainer latch up and off the system board.
b. Follow steps a on page 57 through d on page 57.
c. After the replacement microprocessor, reinstall the adapter board retainer
latch by reversing step a. above.
Note: If a terminator card is being installed in microprocessor slot #1, it is
not necessary to replace the adapter retainer latch.
Clip
Heatsink
Microprocessor
Terminator card
Heatsink release
lever
Slot
Top view of
heatsink