Filter
Top Products
Copyright © 1997-2004 InFocus Corporation.
All Rights Reserved.
ASK Proxima DP9200 Projectors
Frequently Asked Questions
How do I set up the DP9200/9210 remote mouse?
The DP9200 can emulate a mouse when connected to a computer using one of the remote mouse cables (serial, PS/2 or Mac
ADB) provided with the projector. In most cases, the DP will automatically detect and configure the remote when the
computer boots. There are a few cases where the DP will not be detected as a mouse.
Before you begin, ensure that if using:
Windows 95: In Control Panel, if using the serial 9-pin remote cable, verify that the mouse driver being used is a Microsoft
Serial Mouse Driver. Otherwise, use the Microsoft PS/2 Mouse Driver when using the PS/2 remote cable.
Windows 3.1: In Windows Setup, the mouse driver should be set to Microsoft or IBM PS/2 mouse (when using either the
serial or PS/2 remote cable).
Macintosh: Try loading the Macintosh without any extensions loading. Verify that AppleTalk is disabled. If necessary, disable
any modems.
• Turn off your computer and disconnect the external mouse (if applicable).
• Connect one end of the Proxima remote cable to the computer's 9-pin serial, PS/2 or ADB port and the other end
into the CONTROL port on the projector.
• Turn on the projector and light the lamp.
• Turn on your computer. It should detect the projector as a mouse.
• Use the circular mouse pad to control the mouse pointer.
If the steps above do not activate the remote mouse, follow the troubleshooting steps below:
• Verify there are no Cyclops drivers loading. (please see next question for instructions on how to remove Cyclops
drivers)
• Verify an external mouse works in the same port that is used for the DP5600 mouse. (Example, if using the serial
port on your PC, test the port with a 9-pin serial mouse, etc.).
• Verify that the various functions on the remote work.(ex: Can it bring up the menus?) If not, try replacing the
batteries.
• If unable to operate the remote mouse, power down the projector and wait one minute (leave PC/MAC powered on).
Turn the projector back on. The remote mouse should now work.
How do you find the lamp hours on the DP9200?
Push the Up-Arrow button (on keypad) for about 20 seconds. The lamp hour that is left will be displayed in the screen.
A display will appear near the top, middle of the display. Lamp hours remaining are under "Data".
Example:
Service Data No. Data
Mode 37 1888
Lamp "ON" time will be: 1900* - 1888 = 12 hours (* highest value when lamp hours are started or reset)
What are the scan rates for the DP9200?
• H-Sync: 15KHz - 81KHz
• V-Sync: 50Hz - 100Hz