Filter
Top Products
Intermate100 and Intermate101 Print Server Administration Manual 150
Network Destination Option: Changes Needed on Other Configuration Pages
19.7. Changes Needed on Other Configuration Pages
19.7.1. Local Printer—Do Not Enable Power Detection
When you enable NDO, you should also set “Enable Power
Detection” on the Local Printer to “No” (see
“Enable Power
Detection” [page 143]
).
19.7.2. System Target Printer in a “Stand-Alone” Setup
The print server does not need to be physically attached to a
Local Printer. When thus used as “stand-alone”, only four tar-
get printers can be supported; and all four of them are network
destinations.
If you use this setup, you must be sure to set [General] > “Sys-
tem Target Printer” to a network destination (see
page 108
).
Otherwise you can end up hanging the whole system, because
everything carried by Logical Printer 0 as well as the “Main Sta-
tus Pages” gets directed to the System Target Printer.