Filter
Top Products
2828
1 POWER switch (DT-V9L5 only)
Turns AC power on or off.
● You need to press button (☞ q on page 27) to use the monitor after turning on the POWER switch.
Rear panel
Index of Parts and Functions (cont.)
Security slot
Attach a security wire to this slot.
Histogram
y SCOPE button/lamp
Displays/hides the indication of the wave form monitor and vectorscope (☞ “Scope Setting” on page 36).
● Each time you press this button, the window changes in the following order.
Wave form monitor
Vectorscope
No display
u For DT-V9L5: DC lamp / For DT-F9L5: BATT. lamp
When the DC power voltage is being lowered due to the battery consumption, the lamp changes to orange from green. When the voltage
becomes lower than a certain level, the monitor automatically turns off and the lamp turns to red.
●
For DT-V9L5: Make sure to turn off the POWER switch (☞ 1 on page 28) and DC switch (3 on page 29) on the rear panel before replacing
the battery. / For DT-F9L5: Make sure to turn off the POWER switch (☞ 3 on page 29) on the rear panel before replacing the battery.
● The length of time that the lamp lights in orange differs depending on the type of battery or the battery condition. It is recommended to
replace the battery when the lamp turns to orange.
Battery mount
(☞ page 26)
DT-V9L5
DT-F9L5
Common
Carry handle
Use this handle when carrying the monitor.
Carry handle
Use this handle when carrying the monitor.
Back tally lamp
This lamp is controlled by the tally
function of the MAKE/TRIGGER terminal.
The setting of the lamp is linked to •
the red tally lamp on the front panel.
(☞ “Tally Setting” on page 37 and
“External Control” on page 42)