Filter
Top Products
20
|
English
■ Setting the Monitor Unit
Accessory D
Accessory G
Protective strip
Tighten
Loosen
Installation surface
Tighten
Loosen
1
Bend the stand support to conform to the
shape of the installation location.
2
Adjust the shape of the support so that there is
no rattling or gap when the stand is placed on
the support.
3
Peel off the protective strip from the double-
sided tape on the bottom of the stand and
securely attach the stand.
• Do not attach the double-sided tape more than
once or touch the adhesive with your fingers as this
will weaken its adhesive strength.
• If the temperature of the surface of the installation
location is low, warm it up using a heater or
other means before attaching the stand. Low
temperature may weaken the adhesive strength of
the tape.
• The supplied stand is specially intended for this
product. Do not use it with another monitor.
4
Secure the stand (Accessory D) using the
supplied tapping screw (Accessory G).
5
After attaching the stand, allow it to sit
undisturbed for 24 hours.
6
Take care not to apply any force to the stand
during this time.
7
Fully loosen the installation screws, align the
slit on the rear of the unit with the installation
shoe and slide the monitor unit onto the stand.
8
Adjust the height, horizontal angle and vertical
angle of the monitor and securely tighten the
installation screws.
You can also adjust the monitor unit's forward
position by loosening the angle adjustment
knobs and adjusting the angle of the monitor
unit's installation stand.
• Attach the monitor to the bracket securely until it clicks.
Installation for Monitor Unit