Filter
Top Products
Operating Procedures
3-32 September 2000
Resetting the Copyright Detection LUTs
This procedure resets the Copyright Detection LUTs stored in nvram to the factory
setup (default) values. To indicate that the values have been reset to the factory
setup values, the word “done” is displayed in parenthesis after “Reset Copyright
LUTs To Factory” on the menu.
1. Select “Setup” from the main menu on the OCP.
2. Select “Defaults”.
3. Select “Reset Copyright LUTs to Factory”.
4. Select “Exit” to return to the previous menu on the OCP.
Selecting the SCSI Ports
1. Select “Setup” from the main menu on the OCP.
2. Select “Ports”.
3. Select “SCSI”.
4. Select “SCSI Target ID”.
5. Use the Up and Down Arrows to select a new SCSI ID. Valid SCSI IDs are 0,
1, 2, 3, 4, 5, 6, 7.
NOTE: Make sure the number you select for the SCSI ID has not been assigned
to another device.
6. Press Select to select/set the new value.
7. Select “Exit” to return to the previous menu on the OCP.
Setting the Target Pad Reads
1. Select “Setup” from the main menu on the OCP.
2. Select “Ports”.
3. Select “SCSI”.
4. Select “Target Pad Reads”.
5. Use the Up and Down Arrows to select “Yes” or “No” to indicate whether or
not the SCSI device driver will pad initiator read requests with zeros to the
requested length or simply terminate the SCSI read transaction when it has
sent only the data it has to send.
6. Press Select to select/set the new value.
7. Select “Exit” to return to the previous menu on the OCP.