Filter
Top Products
Diagnostics and Troubleshooting
5-18 September 2000
704 CalToleranceFile::
initialize must be called first.
An internal error occurred with the
software.
• Restart the application.
• If problem continues, call for
service.
801 Could not find row:_row_. An internal error occurred with the
software.
• Restart the application.
• If problem continues, call for
service.
802 Could not find
column:_column_.
An internal error occurred with the
software.
• Restart the application.
• If problem continues, call for
service.
803 Could not find element -
column:_column_.
row:_row_.
An internal error occurred with the
software.
• Restart the application.
• If problem continues, call for
service.
804 Row value was not set
before using.
An internal error occurred with the
software.
• Restart the application.
• If problem continues, call for
service.
805 Column value was not set
before using.
An internal error occurred with the
software.
• Restart the application.
• If problem continues, call for
service.
806 Error deleting row:_row_. An internal error occurred with the
software.
• Restart the application.
• If problem continues, call for
service.
807 Element at row:_row_;
column:_col_
value:_val_ failed audit.
An input file had incorrectly
formatted data in it at the location
indicated.
• Verify that you are using the
correct file.
• Edit the file and correct the
format.
910 Configuration file
field:_filename_is invalid.
Calibration will be cancelled.
The user manually edited a field
in a configuration file and entered
an incorrect value.
• Manually enter the correct
value.
• Reinstall the application.
• If problem continues, call for
service.
911 Error_errcode_occurred.
Processing stopped.
An internal error occurred with the
software.
Restart the application.
919 Error occurred preparing to
handle exit from Kodak
Calibration. Will not perform
cleanup at exit.
An internal error occurred with the
software.
Restart the application.
921 Unable to return the printer
to its original state. Fix
printer problem and re-
calibrate.
The application was trying to
cancel but received an error when
sending the original LUT back to
the printer.
Printer is in an unknown state.
Correct any printer problems and
restart the application.
922 There is already a printer
open. Please close the open
printer first.
User tried to open a printer when
the printer was already open.
Close the open printer.
Error
Code
Error Code /Status
Message
Possible Cause/Subsystem Possible Solution