Filter
Top Products
Specifications
September 2000 B-3
Electrical
The KODAK PROFESSIONAL LED II Printer 20R is manufactured to operate
within one of the following sets of power constraints or can be configured to do so
by a Kodak representative:
* Phase selection must be completed at the factory or by a trained Kodak
representative.
* *Outside the U.S. and Canada, amperage for the printer is 16A.
Consult with your electrical contractor or utility company to ensure that on-site
wiring complies with the printer specifications and that wall outlets use isolated
grounds and comply with codes. Further information is provided in the following
sections.
If the equipment is to be permanently connected, then the equipment must be
provided with its own circuit breaker that is located near the equipment within
easy reach of the operator and marked as the disconnecting device for the
equipment.
The unit is an Insulation Category Type II machine, and operates in a Pollution
Degree 2 environment in accordance with IEC 664 (Normal Office Environment).
For technical support, service, repair and fuse replacement information, contact
Eastman Kodak Company’s Technical Assistance Center at 1-800-822-1414.
Power Cords
A 2.4 m (8 ft.), grounded power cord with a special three prong plug is provided
with your printer. The printer conforms to the NEMA N6/15 Printer Plug
Specification.
Special plugs and cords may be required outside of the United States and
Canada. These plugs and cords will be provided by the Kodak distributor (the
power cord provided for international locations must have at least 14 gauge wire).
The power cord should be certified and approved by a national test house.
CAUTION: Make certain nothing obstructs or is placed on power cords. Do
not use extension cords; they can cause voltage loss which may
result in unreliable equipment performance or equipment
damage.
Nominal Voltage/Frequency Voltage Range
Power
Consumption
200 - 240V, 15A, 50/60 Hz,
1 phase*
190 - 254V, 47 - 63 Hz,
1phase, 15 A (Automatic
Sensing)**
Less than
2.4kVA