Filter
Top Products
March 1998 C-1
Appendix C: About SCSI Connection
A SCSI terminator is included with the Kodak Professional
8657 thermal printer. You must obtain the proper cabling
required for your configuration and system from your
printer retailer or distributor.
The two SCSI connectors on the back of the printer are
female submini, 50-pin SCSI II connectors.
Windows Systems
To connect the Kodak Professional 8657 thermal printer
(8657 printer) directly to your computer (or to daisy-chain
the printer through an external SCSI device), perform the
following steps.
1. Set the SCSI device number using the 8657 printer’s
display panel.
The 8657 printer is set at the factory for SCSI ID 5. If
you need to change the SCSI ID, refer to the user’s
guide for the Kodak Professional 8657 thermal printer
for instructions about setting the SCSI device number.
2. Turn off all equipment before connecting or
disconnecting any equipment from the SCSI bus.
3. Install the SCSI host adapter board in the computer.
4. Attach a SCSI cable appropriate to your equipment’s
configuration.
5. Attach a SCSI terminator.
NOTE: Some equipment is internally terminated.
Refer to the equipment documentation for
details.