Kodak CCPR11 Printer User Manual


  Open as PDF
of 4
 
TECHNICAL INFORMATION DATA SHEET
CCPR11 Revised 7-04
Copyright, Eastman Kodak Company, 2004
CURRENT COLOR PRINTER RECOMMENDATION: BLACK-AND-
WHITE PRINTING / MONITOR MODE
Printing on KODAK PANALURE SELECT RC Paper Using the KODAK
ACCUDATA Printer Controller XL or The KODAK Digital Printer
Controller
1) General Information
General Setup Information
Note: CCPR VALUES ARE NOMINAL. THEY SHOULD BE USED AS A STARTING POINT FROM WHICH
CUSTOMERS MAY OPTIMIZE THEIR ANALYZER/PRINTER SYSTEM BASED UPON THE PLANT'S FILM
POPULATIONS.
KODAK PANULURE SELECT RC Paper is designed for making black-and-white prints from color negatives.
Following are some setup recommendations for printing negatives on L, M, or H paper grades using the KODAK
ACCUDATA Printer Controller XL or the Kodak Digital Printer Controller (DPC).
Use the nominal CCPR values as a starting point to optimize your printer.
• Install a 1/16-inch 2337 acrylic plastic diffuser in the negative mask plate.
• Use a 600-watt FFJ printing lamp.
• Use a KODAK Neutral Cold Mirror, Notched (CAT No. 147 9005) for the VCL lamphouse or a KODAK Neutral
Cold Mirror (VCB) (CAT No. 110 3795) for the VCB lamphouse.
• Use a KODAK PROFESSIONAL PORTRA Normal Negative (Size 120, CAT No. 846 0948), or a KODAK
PROFESSIONAL PORTRA Printer Control Negative Set (Size 135, CAT No. 179 8511) to adjust and control the
printer balance.
• Use a starting print density on 0.60 on the normal gray patch of the Normal Control Negative.
• Use a dead heat setup time of 0.70 seconds.
Recommended Starting Lens Diaphragms:
L Contrast Grade M Contrast Grade H Contrast Grade
312 Upper Track
G crop to 8 x 10
38 44 60
312 Lower Track
G crop to 5 x 7
32 38 51
DCP-8 Printers
G crop to 8 x 10
35 41 56
next